The effects of the diluent, the container, the i.v. set, and the drug concentration on the adsorption of urokinase to i.v. administration systems were studied, along with the compatibility of urokinase with plastic and glass syringes. Solutions of urokinase 1500 and 5000 IU/mL in 0.9% sodium chloride injection and 5% dextrose injection in glass and polyvinyl chloride (PVC) containers were sampled at 2 and 30 minutes. Administration sets were attached to PVC containers containing the urokinase-5% dextrose injection solutions, and samples were collected at 90 and 150 minutes. Glass and polypropylene syringes containing urokinase 5000 IU/mL in 0.9% sodium chloride injection or 5% dextrose injection were sampled at 0, 4, 8, and 24 hours. Urokinase activity was measured by an in vitro clot lysis assay. No urokinase diluted in 0.9% sodium chloride injection adsorbed to glass or PVC containers. For urokinase 1500 IU/mL in 5% dextrose injection, a loss of 15% to 20% occurred almost instantaneously in PVC containers; additional losses to the infusion sets were minimal. However, for urokinase 5000 IU/mL in 5% dextrose injection, no losses were observed in the PVC systems. No drug loss to glass bottles was seen for urokinase 1500 or 5000 IU/mL in 5% dextrose injection. Urokinase potency remained constant in polypropylene and glass syringes for 24 hours. To minimize urokinase sorption to PVC containers, higher concentrations of urokinase diluted in 5% dextrose injection should be used, provided that clinical safety and efficacy are not compromised. The use of 0.9% sodium chloride injection as a diluent also prevents sorption losses.